# To flash
# [*] Enable extra low level configuration options
#     Micro-controller Architecture (Raspberry Pi RP2040]  --->
#     Flash chip (Generic_03H with CLKDIV 4)  --->
#     Communiccation interface (USB)  --->
#     USB ids  --->
# ()  GPIO pins to set at micro-controller startup


# Klipper config for RGBee

[mcu rgbee]
serial: /dev/serial/by-id/usb-Klipper_SERIAL_ID_GOES_HERE
restart_method: command

[board_pins rgbee]
mcu: rgbee
aliases:
  N1=gpio0,
  N2=gpio1,
  N3=gpio2,
  N4=gpio3,
  N5=gpio4,
  N6=gpio5,
  N7=gpio6,
  N8=gpio7,
  LED=gpio16

[neopixel my_neopixel1]
pin: rgbee:N1
#   See the "led" section for information on these parameters.

[neopixel my_neopixel2]
pin: rgbee:N2
#   See the "led" section for information on these parameters.

[neopixel my_neopixel3]
pin: rgbee:N3
#   See the "led" section for information on these parameters.

[neopixel my_neopixel4]
pin: rgbee:N4
#   See the "led" section for information on these parameters.

[neopixel my_neopixel5]
pin: rgbee:N5
#   See the "led" section for information on these parameters.

[neopixel my_neopixel6]
pin: rgbee:N6
#   See the "led" section for information on these parameters.

[neopixel my_neopixel7]
pin: rgbee:N7
#   See the "led" section for information on these parameters.

[neopixel my_neopixel8]
pin: rgbee:N8
#   See the "led" section for information on these parameters.

[neopixel rgbee]
pin: rgbee:LED
color_order: RGB
initial_RED: 1.0
initial_GREEN: 0.0
initial_BLUE: 1.0