# To flash
# [*] Enable extra low level configuration options
#     Micro-controller Architecture (Raspberry Pi RP2040]  --->
#     Flash chip (Generic_03H with CLKDIV 4)  --->
#     Communiccation interface (USB)  --->
#     USB ids  --->
# ()  GPIO pins to set at micro-controller startup


# Klipper config for TeenyTemp

[mcu teenytemp]
serial: /dev/serial/by-id/usb-Klipper_SERIAL_ID_GOES_HERE
restart_method: command

[board_pins teenytemp]
mcu: teenytemp
aliases:
  T1=gpio29,
  T2=gpio28,
  T3=gpio27,
  T4=gpio26,
  LED=gpio16

[temperature_sensor thermistor1]
sensor_type: Generic 3950
sensor_pin: teenytemp:T1
# Change this value and uncomment if you use a different pullup resistor
#pullup_resistor: 4700
min_temp: 0
max_temp: 260

[temperature_sensor thermistor2]
sensor_type: Generic 3950
sensor_pin: teenytemp:T2
# Change this value and uncomment if you use a different pullup resistor
#pullup_resistor: 4700
min_temp: 0
max_temp: 260

[temperature_sensor thermistor3]
sensor_type: Generic 3950
sensor_pin: teenytemp:T3
# Change this value and uncomment if you use a different pullup resistor
#pullup_resistor: 4700
min_temp: 0
max_temp: 260

[temperature_sensor thermistor4]
sensor_type: Generic 3950
sensor_pin: teenytemp:T4
# Change this value and uncomment if you use a different pullup resistor
#pullup_resistor: 4700
min_temp: 0
max_temp: 260

[neopixel teenytemp]
pin: teenytemp:LED
color_order: RGB
initial_RED: 1.0
initial_GREEN: 0.0
initial_BLUE: 1.0