[multi_pin pcf_fan_pins]
pins: PE6, PE0

[fan]
##  Print Cooling Fan - FAN0 - MAKE SURE TO SET THE VOLTAGE JUMPER!
pin: multi_pin:pcf_fan_pins
kick_start_time: 0.5
##  Depending on your fan, you may need to increase this value
##  if your fan will not start. Can change cycle_time (increase)
##  if your fan is not able to slow down effectively
off_below: 0.10

[heater_fan hotend_fan]
##  Hotend Fan - FAN1
pin: PC12
max_power: 1.0
kick_start_time: 0.5
heater: extruder
heater_temp: 50.0
##  If you are experiencing back flow, you can reduce fan_speed
fan_speed: 1

[controller_fan mcu]
##  Controller Fan - FAN4
pin: PE4
max_power: 0.3
kick_start_time: 0.5
stepper: stepper_x
fan_speed: 1

[temperature_sensor CB1]
sensor_type: temperature_host
min_temp: 0
max_temp: 100

[temperature_sensor Manta]
sensor_type: temperature_mcu
min_temp: 0
max_temp: 100

[temperature_sensor _mid_chamber]
sensor_type: Generic 3950
sensor_pin: PA3 # TH2
min_temp: 0
max_temp: 100

[temperature_sensor chamber_insulation]
sensor_type: Generic 3950
sensor_pin: PA2 # TH2
min_temp: 0
max_temp: 100