28 lines
1.3 KiB
INI
28 lines
1.3 KiB
INI
[filament_switch_sensor Runout]
|
|
pause_on_runout: True
|
|
# When set to True, a PAUSE will execute immediately after a runout
|
|
# is detected. Note that if pause_on_runout is False and the
|
|
# runout_gcode is omitted then runout detection is disabled. Default
|
|
# is True.
|
|
runout_gcode: UNLOAD_FILAMENT
|
|
# A list of G-Code commands to execute after a filament runout is
|
|
# detected. See docs/Command_Templates.md for G-Code format. If
|
|
# pause_on_runout is set to True this G-Code will run after the
|
|
# PAUSE is complete. The default is not to run any G-Code commands.
|
|
#insert_gcode:
|
|
# A list of G-Code commands to execute after a filament insert is
|
|
# detected. See docs/Command_Templates.md for G-Code format. The
|
|
# default is not to run any G-Code commands, which disables insert
|
|
# detection.
|
|
#event_delay: 3.0
|
|
# The minimum amount of time in seconds to delay between events.
|
|
# Events triggered during this time period will be silently
|
|
# ignored. The default is 3 seconds.
|
|
#pause_delay: 0.5
|
|
# The amount of time to delay, in seconds, between the pause command
|
|
# dispatch and execution of the runout_gcode. It may be useful to
|
|
# increase this delay if OctoPrint exhibits strange pause behavior.
|
|
# Default is 0.5 seconds.
|
|
switch_pin: FIXME
|
|
# The pin on which the switch is connected. This parameter must be
|
|
# provided.
|