fix: Update to upstream

printer.cfg

@@ -37,12 +37,11 @@ serial: /dev/serial/by-id/usb-Klipper_stm32g0b1xx_32002C000750414235363020-if00
 kinematics: corexy
 max_velocity: 800
 max_accel: 20000
-max_accel_to_decel: 20000
+minimum_cruise_ratio: 0
 max_z_velocity: 15
 max_z_accel: 45
 square_corner_velocity: 8
 
-[temperature_combined]
 [temperature_sensor Skr_Mini]
 sensor_type: temperature_mcu
 min_temp: 0
@@ -53,6 +52,8 @@ sensor_type: temperature_host
 min_temp: 0
 max_temp: 100
 
+[temperature_combined]
+
 [temperature_sensor _chamber1]
 sensor_type: Generic 3950
 sensor_pin: skrPico:gpio27
@@ -67,8 +68,9 @@ max_temp: 100
 
 [temperature_sensor chamber]
 sensor_type: temperature_combined
-sensors: temperature_sensor _chamber1, temperature_sensor _chamber2
-type:mean
+sensor_list: temperature_sensor _chamber1, temperature_sensor _chamber2
+combination_method:mean
+maximum_deviation: 999.9
 
 #####################################################################
 #      X/Y Stepper Settings
@@ -119,7 +121,7 @@ interpolate: False
 run_current: 1.1
 sense_resistor: 0.110
 stealthchop_threshold: 0
-driver_SGTHRS: 90  # 255 is most sensitive value, 0 is least sensitive
+driver_SGTHRS: 80  # 255 is most sensitive value, 0 is least sensitive
 diag_pin: ^PC1
 
 
@@ -236,11 +238,14 @@ y_offset: -2.4
 z_offset = 9.355
 
 [bed_mesh]
-speed: 120
-horizontal_move_z: 2
+speed: 300
+horizontal_move_z: 16
+zero_reference_position: 60, 60
 mesh_min: 8, 22.4
 mesh_max: 110, 105
-probe_count: 6
+probe_count: 3,3
+algorithm: bicubic
+bicubic_tension: 0.2
 
 [gcode_arcs]
 resolution: 0.1